VCV quantisers to my eurorack modular

[geetommy]

I’m outputting VCV quantisers to my Eurorack system and is not getting precise tuned notes. Each VCV quantiser is going from Ableton/ES8 outputs to tuned Eurorack VCO’s (They track perfectly). I’m using the VCV Output 16 module to output CV signals to ES8. I’ve tried using various VCV quantizers, and when using it with VCV vco’s everything works well. Any hints ?

[jomas]

Hey! Have you tried calibrating the voltage inside VCV with Expert Sleepers’ Voltage Controller or Calibration modules? They will both get the job done, but Voltage Controller is paid and does everything for you, while Calibration is free but needs to be manually set up. There’s also a thread here in the community with a detailed guide about sending pitched information from VCV to hardware, I’ll make sure to link it here!

[jomas]

There you go:

Pitch-accurate sequencing between Rack and hardware - an illustrated guide

This is an illustrated guide to sequencing hardware from Rack, and sequencing Rack from hardware, with accurate pitch, using a DC-coupled audio interface. When using Rack together with hardware synthesizers, be they modular or other synths, there’s lots of attractive opportunities for integrating them, into a combined, hybrid system. This can be done over MIDI or over audio channels, and the following deals with the audio based option. Sending audio, triggers, gates, LFO’s, envelopes and such s…

There’s also Tunathor by Nysthi that performs that same function as well!

[koen.kaptijn]

There is a very informative video about this by Omri Cohen. Around 10:10 it is specifically on calibrating ES modules ES-9 and/or ES-8

5 Ways to build a Hybrid Setup / VCV Rack & Eurorack

Edit: sorry reply is for OP

[geetommy]

Awesome - thank you so much guys