Using Exper Sleepers ES-3 with VCV Rack Tutorial

VCV Rack
1

In this video, I take a look at how to send control voltage and audio from VCV Rack to hardware with using the ES-3 module from Expert Sleepers.


I start with how to calibrate the hardware oscillators and tune them to VCV Rack with using the Silent Way module for VCV Rack, and then I send 2 sequences and gates to the Neutron, and also audio to Morphagene.
2 Likes
2

Thanks Omri. Is ADAT only found on expensive audio interfaces?

3

Well, it depends what you consider expansive… There is this one from Behringer - https://www.thomann.de/de/behringer_umc1820.htm
and this one from Focusrite - https://www.thomann.de/de/focusrite_scarlett_18i20_2nd_gen.htm
This one also looks good - https://www.thomann.de/de/motu_track16.htm

1 Like
4

I got an RME Digiface USB some months ago and I‘m really happy with it. But: ADAT only!

2 Likes
5

If you put o-rings behind the tune knobs on the Neutron they won’t get knocked wonky so easily.

Both the of following have worked well for me:

DASH# 202 or Metric 3.5 x 6 x 13
DASH# 112 or Metric 3 x 6 x 12

It’s easy to adjust how tight they hold the knob by how much the knob is pushed down.

1 Like
6

Funny, I just saw a video about this today… I chose but to replace the knobs with smaller ones. As much as the rings can help, it will still get a bit out of tune so I guess it’s better to avoid touching them completely… Thanks for the tip though, maybe a combination of both is also a good idea.