I am sorry, but why does my Twin Slide not start, even when I hooked it up to Clocked and I pushed Run?
Can you post a screenshot of your patch?
Crank the clock rate to 96x. It’ll start doing 16th notes.
However, I don’t see this behavior with other sequencers I’ve tried in VCV Rack so I think this is a bug. Hopefully it gets resolved.
The internal resolution of 24x expects 96x to be able to use the triplets etc. if you have no interest in using triplets you can set the internal resolution to a lower rate, by long pressing length/mode button. Same as in Impromtpu Modular - PhraseSeq32.
A default for new instances of the module can be set by right click context menu.
Hope that clarifies it.
2 Likes
I just find it slightly annoying that the internal sequencer and clock resolution isn’t consisent with the other VCV sequencers I’ve tried. Not that I’ve tried all but it’s the first I’ve encountered like this. If I use this, I will most likely sequence it externally.
The rest of the module sounds very good. Thank you for you work and contribution.
1 Like
Thanks for the feedback,
the default pulses per step (PPS) will be set to 1x, in the next update. This should avoid any confusion.
3 Likes
Hello there and friendly greetings!
First of all: great modules! Seriously, what amazing souds!
I have a tiny questions about the sequence selection knob in the upper right corner of the module. I might have missed the informations about it in the manual from github.
Is there a way to control which sequence plays via a voltage signal? Like with an LFO or a sequencer?
Apart using stoermelder µMAP.
Thanks in advance and have a great weekend!
1 Like
Thanks!
unfortunately not by CV input. the GUI is now full as it is.
Cheers
Alright, no problems! 