Hello, could anybody explain how i could configure the Module to let Deja Vu influence the Clusters Mode? Is it possible?
Karl
I didn’t dare address him directly. Thought it was a question that could be answered by the community.
Karl
Have you read the Manual ?
yes i did, but do not understand the details. e.g. i only use the t-generator in mode clusters. if deja vu is in 12 o clock, then it should loop and no other random is generated. but if i move the bias knob, the results on the both outputs change. dont know why, or do missunderstand somenthing?
I think the bias is overruling the Deja Vu, but after releasing the bias, it will come to a “new” x-step loop (x being the number of steps set by the length).
Deja Vu mode doesn’t “store” the gates and values it generated. Instead, it stores the initial random value it used to generate them.
When you change the bias knob, you’re changing how it interprets those stored values. If you put the bias knob back where it was, you’ll get the same output you had before.
OK, thank you. a bit clearer. but not completely. the following scenario: I let the bias in 12 o clock. mode is cluster. length is 8. I activate Deja vu for t-generator. now I turn the knob from deja vu to the left. according the manual new random values are imported. if I turn the knob back to 12 o clock it should locked. but the pulses per step vary randomly. is this intended? or am I wrong?