Daws Loop region is causing my sequencer to stop after first cycle is complete

Hi guys, I’m fairly new to vcv and while Im enjoying figuring out stuff/ looking up tutorials, I can’t figure this out myself. Hi have bidoo encore sequencer clocked by inpromtue clocked and as the title suddjests whenever the Daw (Bitwig) reaches the end of the cycle loop it stops the sequencer in VCV, but just for encore and it starts up again at the start of the 3rd cycle . So basically initial loop on second off third on etc. And if I start the Daw anywhere during the second cycle (when encore is off), it wont restart no matter how many times I restart the Daw until it completes the full cycle loop and it start all over again. I think this is only happening with encore but I think it may be hapening with other vcv sequencers as well. Id really appriciate any help with this as its messing up my workflow

Hi @dangerousgar please share your patch and your bitwig project file or share at least a video where we can see what’s going wrong.

Sounds like a gate/toggle issue… Sharing the patch helps investigating!

Edit: sorry wrong reply button :slight_smile:

1 Like

cycle loop zone issue.vcv (6.4 KB) I have never tried sharing a patch before so bear with me, and thanks for the responses.

I loaded your patch into the VCV Rack VST inside Bitwig Studio and found no issues. How long is your loop in Bitwig Studio? Did you apply any automations?

HI Ahornberg, its a 16 bar loop and definitely no automations, as I said it only seems to be effecting the Encore sequencer. V strange cant figure it out!

May you share a video that shows us what’s going on? This would help.