Bogaudio UMix question

So, I use UMix a lot…as a sort of “Or” function, especially with gates/triggers (0-10v). I just noticed that combining two gate sources, each of which would be either 0 or 10v, that the output is either 0 or 9.48V. Clipping and averaging is off and gain is 0. Why is the output not 10V when one of the gates is high? It doesn’t matter on somethings, but I just noticed it because what follows in this patch is set to run at 10V specifically. I can use an OR module (which is fine), but can someone help me understand? Thanks!

Choose “Hard/clipped” in the Output clipping.

1 Like

1 Like

Thanks! I knew I was missing something simple!