Hi, I was wondering if there is a way to kind of reset the config for the audio modules as, for some reason, all of them on my PC have deviced to set the sample rate to 48k, then 44.1 each time a patch is loaded.
Windows 11, Focusrite Clarett 4Pre (USB), targeting 44.1k/24bit.
Here is the relevant log area:
[0.333 info src/engine/Engine.cpp:1430 fromJson] Creating module VCV Audio 8
[0.333 info src/rtaudio.cpp:52 RtAudioDevice] Creating RtAudio ASIO device
[0.335 info src/rtaudio.cpp:119 openStream] Opening RtAudio ASIO device 1: Focusrite USB ASIO (18 in, 8 out, 48000 sample rate, 256 block size)
[0.914 info src/rtaudio.cpp:129 openStream] Starting RtAudio ASIO device 1
[1.338 info src/rtaudio.cpp:147 closeStream] Stopping RtAudio ASIO device 1
[1.372 info src/rtaudio.cpp:151 closeStream] Closing RtAudio ASIO device 1
[1.374 info src/rtaudio.cpp:119 openStream] Opening RtAudio ASIO device 1: Focusrite USB ASIO (18 in, 8 out, 44100 sample rate, 256 block size)
[4.193 info src/network.cpp:155 requestJson] Requesting JSON GET https://api.vcvrack.com/version?edition=Pro
You can see it sets up 48k then switches to 44.1k hen proceeds normally.
I want 44.1 but my Interface takes time to sync to 48 then back to 44.1 every time I load rack. VCV Rack’s engine sample rate is set to 44.1. The settings file in appdata confirms this. I’ve tried “Auto”, deleting the settings file, disabling all other audio devices on my PC and testing with each of the audio modules, same thing.
Windows audio is set to 44.1/24bit as is the setting in Focusrite Control.
I used to run my audio at 48k but stepped down to 44.1 to save spiking the CPU. I suspect there is a remnant somewhere. Anyone know where it might be before I bother support with, what is after all, an inconvenience rather than a fault. Thanks.