I’ve been enjoying the Trowa cvOSCcv module, mostly using it with TouchOSC on iOS. Single faders and buttons work great, but I can’t figure out how to get XY pads to work. I think it’s because TouchOSC is sending two values instead of just one.
Has anybody had any luck with this?
Maybe I should open an issue on the Trowa Github.
If all else fails puredata can be used to reprocess OSC commands.
I believe trowasoft is intended to be used in this way, since pd patches are used to translate launchpad keys in to trowaSeq commands over OSC.
Thanks for the tip! That’s a good idea.
Just stumbled on this today. In case you haven’t figured it out yet, cvOSCcv has poly ins/outs. So, you would set up a channel like “/1/xy1” and connect that channel to a VCV Split module. I would also suggest adjusting the “ADV” setting for that channel to scale the values to a range that fits your use case. Probably -10 & 10 on the CV out, and 0 & 1 on the OSC in (make sure “convert values” is checked).
a comprehensive tutorial would be greatly appreciated.
why? touchosc provides a powerful and flexible control surface which many vcv users might enjoy, and it runs on ios 9 devices which can be had for dirt cheap or less.
also, an open question: how many bits of resolution do these controls have? it seems the answer is 32 which is drastically superior than 7 bit midi cc.