I haven’t really used Fundamental Sequential Switch 2 since version 0.6 because I could never quite figure out why it won’t output sometimes after v1.0 was released. I was starting to think the module was just mad at me for turning it black and just used Bog’s 8:1 which is overkill if you only need a couple steps. Finally I noticed it won’t output unless input 1 has something plugged into it. Anyone else have this same behavior with SS-2? I have no clue if this is intentional or what, but for now I will just plug in 0V into input 1 even if I don’t intend to use input 1.
Andrew said it is fixed ( in the next release ) :
Ah geez, I didn’t realize that was a known issue. To the forum moderators, feel free to delete this post, or let me know if I should. Thanks so much for this info @Yeager.